Shiro ADSL 2/2+ Ethernet Modem Uživatelský manuál stáhnout pdf (Strana 559)

100

101

)*+,,*

-./





!

))0+)01++,

=!

)(+

42!

**20

STLF-NA-TRD-REQ-0340 The RCST shall sniff the LAN segment to include the entries of the hosts

MAC@ in the LAN into the ART with RCST destination equal to itself. It can

do it by looking at the source MAC@ of the ethernet messages.

NA - -

STLF-NA-TRD-REQ-0350 If it does not exist a L2-connection with the terminal destination of an

Ethernet message the RCST shall drop the packet.

NA - -

STLF-NA-TRD-REQ-0360

(OPT)

SatLife system shall support spanning trees on the RCST being built based

on sniffed data in the LAN segment and static configuration.

NA - -

STLF-NA-TRD-REQ-0370 SatLife system shall ensure the uniqueness of PIDs for the reception and

transmission of data.

NA - -

STLF-NA-TRD-REQ-0380 SatLife system shall allow a special configuration for the star topology and

Prosumer subscription where the RCSTs are not interconnected between

them and only “bridged” to the RSGW (see figure below). To implement this

the RCSTs shall only be configured with the broadcast PID of the RSGW so

they cannot see any broadcast message going out from another RCST in the

same VSN.

NA - -

STLF-NA-TRD-REQ-0390 SatLife system support of semi-dynamic bridging shall ensure static

configuration of bridge data in RCSTs including:

 semi-dynamic bridge data configuration in RCSTs (via CLI or HTTP):

NA - -

STLF-NA-TRD-REQ-0400 The SatLife system semi-dynamic bridge mode shall support locally (via CLI

/HTTP or SNMP) and remotely bridge data configuration (via telnet of SNMP)

over RCSTs on bridge mode.

NA - -

STLF-NA-TRD-REQ-0410 SatLife system shall consider as the semidynamic bridge data to be

configurable in bridge mode RCSTs the following parameters:

 Bridge broadcast reception data: couples (RCST MAC@- forward PID)

used by the terminals to transmit broadcast messages.

NA - -

STLF-NA-TRD-REQ-0420 The broadcast L2-connection for each terminal shall be created as

permanent (NCC-initiated) when the RCST logs on in the network. It will use

the SLAs defined in the VSN per RCST.

NA - -

STLF-NA-TRD-REQ-0430 The unicast bidirectional L2-connections between terminals are created as

permanent (NCC-initiated) when both RCSTs have logged on in the network.

It will use the SLAs defined in the VSN per RCST.

NA - -

STLF-NA-TRD-REQ-0440 SatLife system shall release the connections of a terminal that has logged off. NA - -

STLF-NA-TRD-REQ-0450 When the NCC releases a L2-connection in a terminal, the RCST shall delete

the entries of the ART of those hosts MAC@ belonging to the remote RCST.

NA - -

1 2 ... 554 555 556 557 558 559 560 561 562 563 564 ... 637 638

Komentáře k této Příručce

Žádné komentáře

Shiro ADSL 2/2+ Ethernet Modem Uživatelský manuál Strana 559

Komentáře k této Příručce